RE: X10 Slow

["Pedro de Oliveira" <p.oliveira@xxxxxxx>]

Mark

Is homeseer triggering the kitchen light or is it just keeping tabs on
its state. I find that if you introduce homeseer (or any other software)
into motion detection, it takes forever for the light to switch but if
you use the MS to trigger the light then it is considerably quicker.

HTH
Pedro

-----Original Message-----
From: Mark Walker [mailto:davros@xxxxxxx]
Sent: 31 August 2003 09:33
To: ukha_d@xxxxxxx
Subject: [ukha_d] X10 Slow


Hi
Is X10 known to be Slow, or is it because I am using Homeseer on a
PC.
One example is I have a kitchen light that comes with a motion
sensor.
It is activated by an Event in Homeseer, Motion detected and it is
after sunset.
However you can get in the kitchen and back out again before the
light comes on, probably 10 to 15 seconds later. The same happens
with all of the others. The Front door is meant to turn the porch
light on, but you are in the house before the light comes on. Any ideas
Thanks Mark



** UKHA2004 BE THERE! ** - start planning now.

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/