Re: Probe Hub Update

[Frank Mc Alinden <fmcalind@xxxxxxx>]

Hi Steve
=20=20=20=20=20=20=20=20=20=20=20=20
Didnt explain that too good ...What i meant was that it would m=
onitor the "Actions"of the momentry switch.. ie 0% or 100% but
not % bright=
ness....Doesnt homevision keep track of each load ???
Frank
----- Original Message -----=20
From: Steve Morgan=20
To: ukha_d@xxxxxxx=20
Sent: Tuesday, October 14, 2003 6:17 AM
Subject: RE: [ukha_d] Probe Hub Update


Frank,

I don't think that's going to be much use, because it operates
independantly of the X10 control.

Better would be to have something measure the average output voltage and
have a threshold to differentiate between off and on.=20

Steve

> -----Original Message-----
> From: Frank Mc Alinden [mailto:fmcalind@xxxxxxx]=20
> Sent: 13 October 2003 21:09
> To: ukha_d@xxxxxxx
> Subject: Re: [ukha_d] Probe Hub Update
>=20
>=20
> Hi David
>             I probably should clarify my idea of monitoring=20
> the LD11 status...My intension was to monitor the momentry=20
> switch which i believe turns the module on 100% or 0%....i=20
> would not intend to monitor the actual brightness %  ..I m=20
> assuming hv would be able to do this and it would only be a=20
> problem it the power was turned off then on ??..If theres=20
> enough interest for the momentry monitoring then i will have=20
> a look at it......Probably a din rail version of the Probe=20
> zone Monitor...