The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: ir rx tip



Hi Ian
Yes i also use the 1 amp for pic projects and that but the Zone Rx Unit has
only 1 ic an led and the ir receiver to drive.......milli milli
amps........not driving the ir from here either..

Frank
----- Original Message -----
From: ian.bird@xxxxxxx
To: ukha_d@xxxxxxx
Sent: Friday, April 25, 2003 6:18 PM
Subject: Re: [ukha_d] ir rx tip


Hi Frank

I have gone over to the 1 amp versions in most of my stuff. The little
buggers used to get a little hot for the circuits I have been building
recently. Again, voltage output is 5.1 on the button for all that I have
tested. These are micro circuits but not IR.

Ian





"Frank Mc Alinden" <fmcalind@xxxxxxx>
25/04/2003 08:19
Please respond to ukha_d


To:     <ukha_d@xxxxxxx>
cc:
Subject:        [ukha_d] ir rx  tip


Hi All
Just a little tip for those who are making their own ir receivers
and may at some stage have the following problem.. I have been building
some FirM Rx Units and noticed while testing that with some the Busy
output was flashing briefly and quite often as  if ir was being
received...First covered the ir reciever to block any stray ir but no
good...replaced the ir receiver still no good replaced all caps and ic
........and was ready to take all my ir receivers back to my supplier to
say they were faulty and thought i would try the little 5v 100mA regulator
and bingo the fault cleared replace the regulator on another board and the
fault also cleared...Im not sure why the glitches were getting on the rx
line unless maybe  noise..........so watch those pesky little regulators
..........

Frank Mc

[Non-text portions of this message have been removed]



** UKHA2003 BE THERE! Details here: http://www.automatedhome.co.uk/article.php3?story_id=1110
**
http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/






[Non-text portions of this message have been removed]



Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.