The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Re: ds1820 temperature sensors and epoxy question



A tip, put a small crock clip on the sensor leg near the chip when you
solder to it, that way it will shunt any heat and prevent damage to the ic.

Alancc
----- Original Message -----
From: <patrick@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Thursday, February 27, 2003 2:49 PM
Subject: [ukha_d] Re: ds1820 temperature sensors and epoxy question


> --- In ukha_d@xxxxxxx, Stephen <mail@s...> wrote:
> > Hello,
> >
> > I have given up trying to find anyone selling to92 transistor
> sockets
> > to fit the ds1820 sensors to, so I guess I'll just have to solder
> > direct to the ic.
> >
> > To prevent the legs short-circuiting, I will cover them in a blob
of
> > epoxy. Should I buy the expensive electrically insulated epoxy,
or
> can
> > I cheat and use Araldite, or does that conduct?
>
> Araldite should be fine.
> But you might be better off using heatshrink tubing. It's look nicer,
> and is easier to work with.
>
> Patrick
>
>
>
> http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>




Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.