The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: CBUS then?....


  • To: ukha_d@xxxxxxx
  • Subject: Re: CBUS then?....
  • From: "Patrick Lidstone" <patrick@xxxxxxx>
  • Date: Mon, 26 May 2003 16:33:13 -0000
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

--- In ukha_d@xxxxxxx, "Mark McCall" <mark@a...> wrote:
> > - It can intelligently map events reported by HV to xAP messages
and
> > intelligently map xAP messages in HV commands, without the need
for
> > any extra work.
>
> OK..this sounds good.  Could I use say the "G" housecode in
HV's
X10 Device
> table to be C-Bus stuff?
>
> Then a "G1 ON" would be sent (by DDE?) to your app and
translated
to Clipsal
> Speak?

Yes, you can certainly use it that way (although you can also get a
bit more sophisticated than just plumbing Clipsal in as an X10
replacement ;-). Are you volunteering to beta test :-)

>From what you've said, I guess that you are using the first config
(HV + HV software on 24/7 PC) ?

Patrick



Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.