[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
RE: Re: Splitting composite video
- To: <ukha_d@xxxxxxx>
- Subject: RE: Re: Splitting composite video
- From: "Paul" <groups@xxxxxxx>
- Date: Wed, 21 May 2003 14:56:17 +0100
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- Reply-to: ukha_d@xxxxxxx
Thanks Keith, would they drop straight into the circuit as a direct
replacement I mentioned at:
http://home.maine.rr.com/randylinscott/jan98.htm
?
Ta,
Paul.
P.S. still editting your video!
-----Original Message-----
From: Keith Doxey [mailto:ukha@xxxxxxx]
Sent: 21 May 2003 14:49
To: ukha_d@xxxxxxx
Subject: [ukha_d] Re: Splitting composite video
Analog Devices AD828
Elantec EL2244
Both Dual Opamps capable of video. Used hundred of them :-)
Keith
--- In ukha_d@xxxxxxx, "Paul" <groups@s...> wrote:
> Oh, and I found out the op amp used in the circuit (CA3100) is
obsolete so I'm at a bit of a loss now :-(
>
>
>
> Help!... Keith??? Stuart??? Frank or any other electronics gurus?
>
>
>
> Paul.
>
> -----Original Message-----
> From: Paul [mailto:groups@xxxxxxx...]
> Sent: 21 May 2003 14:07
> To: ukha_d@xxxxxxx
> Subject: RE: [ukha_d] Splitting composite video
>
>
>
> I've had a look at a few of the circuits on the page Stuart sent
me. I like the look of the following:
>
>
>
> http://home.maine.rr.com/randylinscott/jan98.htm
>
>
>
> Any thoughts on this as there isn't much detail around it i.e. any
particular precautions if I'm going to make it (shielding, layout,
component specs etc). I would make up 5 of the circuits on a
veroboard).
Home |
Main Index |
Thread Index
|