The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

CM11A Problem Solved


  • To: ukha_d@xxxxxxx
  • Subject: CM11A Problem Solved
  • From: "Stainton-James, Mark (London)" <stainmar@xxxxxxx>
  • Date: Tue, 14 Jan 2003 10:04:48 -0000
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

I was having some problems last week with my CM11A that would seem to take
ages to send X10 commands, although would receive X10 ok. Then after a few
hours would cause Homeseer to lock up completely.

After suggestions from the group (thanks Daniel) I left the CM11A unplugged
for ages, although this seemed to make no difference.  I then changed the
CM11A for a new one, unfortunately still no joy.

Anyway the problem turned out to be a 'small earth leak' on the circuit the
CM11A was on. The 'leak' was not enough to cause trip the mains but
evidently enough to cause X10 problems. 

Thanks again for everyone's assistance.


Mark


http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.