The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Re: Roof Insulation (Was Re: Halogens for thickies)


  • To: ukha_d@xxxxxxx
  • Subject: RE: Re: Roof Insulation (Was Re: Halogens for thickies)
  • From: "Bricknell, Tony" <tony.bricknell@xxxxxxx>
  • Date: Wed, 26 Feb 2003 13:42:22 +0100
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

>IIRC any cables (lighting circuit) need to be protected in plastic
conduit and not allowed to touch the insulation. I assume that this
is because of potential heat build up in the cable causing the
JABSQUEEZE to melt ? If so I'm very wary of fitting halogen recessed
lights into it. Maybe I need to build small "boxes" into the
ceiling at
each light position ?

I believe this is because, for expanded foam polystyrene products, contact
with PVC material causes the oils to leach out of the PVC - you see the
effect when VCR's/DVD players/etc come packed with foam polystyrene ends
and
the mains cable has been in contact with them for a couple of months whilst
it sits on the shelf.  Imagine that over a couple of years...  Think
extended contact makes the insulation brittle..??


Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.