The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: [ADVERT] 1-Wire Modules was 1-Wire Headache


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Appliance Switch for controlling the Heating ??


  • To: ukha_d@xxxxxxx
  • Subject: Re: Appliance Switch for controlling the Heating ??
  • From: Stephen <mail@xxxxxxx>
  • Date: Wed, 29 Jan 2003 13:09:30 +0000
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • References: <NEBBJLCNPLNNBKLAOMDHEEPFDGAA.david.claxton@xxxxxxx>
  • Reply-to: ukha_d@xxxxxxx

Sorry for taking a week to reply, it takes me that long to read all
time messages posted here!

On Mon, 20 Jan 2003 00:15:05 -0000, you wrote:

>Thanks for the reply Stephen. So are you saying if I can hear my boiler
>switching off as soon as I switch off the timer controls I definitely
>haven't got a pump/boiler over-run?

I'm not saying definitely! When whoever it was (sorry I can't
remember) mentioned over-run, I thought oops, I hope my boiler isn't
going to pack-up on me now! I'm not sure which models have it or why
they do. I only know that for my boiler that the on/off switch on the
front does that and does it straight away, so there *seems* to be no
difference which switch you use...so far. Hence I replaced the switch
on the wall with an x10 switch and so far so good after a couple of
months.

>My boiler is due for a bit of a service so I shall check with them and ask
>them if they know of any problems. Problem is I doubt they are going to know
>much about X10 modules.

You don't have to confuse them asking about x10, just ask if you can
switch it on/off safely using the wall switch rather than the boiler
switch. If they say that's safe, change the wall switch to x10.

>I remember someone mentioning the fact that the X10 appliance/light modules
>send through a small amount of current to enable the appliance/light to
>still be switched on manually, does anyone know if this applies to the X10
>appliance/light switches as well?

I thought current sensing was a "feature" of light modules that causes
the flickering of bulbs that are supposed to be off! I didn't think
this applied to appliance modules: any expert care to confirm?

Thanks,
Stephen.


Yahoo! Groups Sponsor
ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.