RE: Are there any UKHA MisterHouse gurus in residence?

["Lee" <yahoo@xxxxxxx>]

Hmmm, replying to myself...

Having found the X10 errata control and cranked it up to full debug
mode
(4),
I have further info.

When I switch on an X10 module from the tk console, MH just spews out
X10
codes
to switch it on again and again indefinately, the logs fill and CPU
usage
rockets...

A reboot fixes it, but that's not much help...

Any ideas?

-----Original Message-----
From:
sentto-1109639-65652-1043705854-yahoo=varga.co.uk@xxxxxxx
om
[mailto:sentto-1109639-65652-1043705854-yahoo=varga.co.uk@xxxxxxx
.yahoo.com]On Behalf Of Lee
Sent: 27 January 2003 22:17
To: ukha_d@xxxxxxx
Subject: [ukha_d] Are there any UKHA MisterHouse gurus in residence?


I'm getting a messages like -

"Data recieved while xmiting data ... recieve and retry"

and

"Bad Checksum im CM11 send : cs1=11 cs2=. Will retry"

On the console logs, the former when I press a button on an X10 remote,
the latter every so often.

The CPU usage also bobs between 30-60% and it's doing 1cycle/sec.

It used to (well two days ago when first installed) display the name of
the
X10
unit as each remote button was pushed, and use 0% while doing
20cyc/sec.

Any ideas?

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.