The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Socket Rocket addressability



On Fri, Oct 18, 2002 at 08:06:02PM +0100, Mark Harrison wrote:
> You use an X-10 transmitter to program it.
>
> You simply screw it into any light fixture, screw in a bulb, turn the power on, and then send it a code from any X10 Controller within 30 seconds . You send the same code three times. When the Socket Rocket receives the same code for the third time it turns on to let you know that it has "learned" the code.
>
> It then remembers this code indefinitely, even if the power fails. To "teach" the Socket Rocket a new code, you just remove the power, reapply it, and then send it the new code three times.  The next Socket Rocket you install will not override the last one due to the 30 second time-to-program feature.

Thanks, Mark, but it doesn't seem to work...

Here's what I did. I put the Socket Rocket in a table lamp, put in a bulb,
switched on then clicked ON followed by OFF three times from my program
which had been set up for House Code - A  Device - 3. I've done this a
number of times. SO I guess, either I haven't got the squence right, or my
software doesn't work, or the LM15 is faulty... Not sure what else could
be wrong. Is there any way to test the device independently? How reliable
are they?

> Regards,
>
> Mark
>
> -----Original Message-----
> From: John Poltorak [mailto:jp@xxxxxxx]
> Sent: 18 October 2002 19:59
> To: ukha_d@xxxxxxx > Subject: [ukha_d] Socket Rocket addressability
>
>
> An additional item I ordered was a Socket Rocket, but here I'm a bit
> stumped. There doesn't seem to be any way to set a device address as there
> is on the lamp and ampliance modules, so how do I get the controller to
> know what to contact? Is there any way to pull it apart to gain access to
> some hidden dials?


--
John



Yahoo! Groups Sponsor
ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.