|
The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024
|
|
[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
Re: Thank You James! - New Pics
Both Xantech and Buffalo have +V, Signal and ground.
Xantech has bare wires, Buffalo has little screw down terminals.
They both appear to have *some* electronics, but I can't see because
they're inside a brass tube. They have talkback LEDs so it may just
be for that?
M.
----- Original Message -----
From: Frank Mc Alinden
To: ukha_d@xxxxxxx
Sent: Tuesday, October 22, 2002 1:43 PM
Subject: Re: [ukha_d] Thank You James! - New Pics
Hi Ken
Do you have any wiring daiagrams for the Buffalo and Xantech rx
units.....Do they have any electronic in side other than an ir
receiver???
For instance are the connections as follows
+12v
signal
gnd
What type of connector is used???
[Non-text portions of this message have been removed]
Yahoo! Groups
Sponsor |
ADVERTISEMENT
|
|
|
|
|
http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
Home |
Main Index |
Thread Index
|
|