RE: Thank You James! - New Pics

["Kenneth Watt" <kwatt@xxxxxxx>]

Sorry Frank just catching up after lunch.

>            
Do you have any wiring daiagrams for the Buffalo and
Xantech
> rx
> units.....Do they have any electronic in side other than an ir
receiver???
> For instance are the connections as follows

I should have some diagrams at home, if I can I'll scan them and send
them later. However the Xantech ones are the same as the pdfs @
http://www.xantech.com/ which should
be a lot better than my scans. To
me the Buffalo tubes look to be the same as the Xantech version and
they
certainly work as the Xantach on the Xantech amp.

> +12v
> signal
> gnd
> What type of connector  is used???

Yes, that is exactly how its done on all the emitters and they came
with
just bare wires, no connector at all.

HTH

K.

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.