The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Thank You James! - New Pics



Thanks Mark
                I dont suppose you would know if the signal back is 12v or
5v........The talk back leds i assume is an indicator to say its receiving
ir........If the signal voltage is 5v then my rx boards could be used....but
they have an rj45 socket on them so need patch leads........Is all your cat5
on Krone panels .......no patch panel??? Some pics when you get a chance
please of the ir units........

Frank


----- Original Message -----
From: "Mark McCall" <Mark@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Tuesday, October 22, 2002 10:49 PM
Subject: Re: [ukha_d] Thank You James! - New Pics


> Both Xantech and Buffalo have +V, Signal and ground.
>
> Xantech has bare wires, Buffalo has little screw down terminals.
>
> They both appear to have *some* electronics, but I can't see because
they're inside a brass tube.  They have talkback LEDs so it may just be for
that?
>
> M.
>
>   ----- Original Message -----
>   From: Frank Mc Alinden
>   To: ukha_d@xxxxxxx >   Sent: Tuesday, October 22, 2002 1:43 PM
>   Subject: Re: [ukha_d] Thank You James! - New Pics
>
>
>   Hi Ken
>               Do you have any wiring daiagrams for the Buffalo and Xantech
rx
>   units.....Do they have any electronic in side other than an ir
receiver???
>   For instance are the connections as follows
>
>   +12v
>   signal
>   gnd
>   What type of connector  is used???
>
>
>
>
>
> [Non-text portions of this message have been removed]
>
>
>
> http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx > Subscribe:  ukha_d-subscribe@xxxxxxx > Unsubscribe:  ukha_d-unsubscribe@xxxxxxx > List owner:  ukha_d-owner@xxxxxxx >
> List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>


Yahoo! Groups Sponsor
ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.