The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: Re: My hardwired IR distribution install pics..


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Thank You James! - New Pics



Hi Ken
            Do you have any wiring daiagrams for the Buffalo and Xantech rx
units.....Do they have any electronic in side other than an ir receiver???
For instance are the connections as follows

+12v
signal
gnd
What type of connector  is used???

Frank
----- Original Message -----
From: "Kenneth Watt" <kwatt@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Tuesday, October 22, 2002 9:11 PM
Subject: RE: [ukha_d] Thank You James! - New Pics


> >             You will have the same problem with ir blasters..using
> FirM
> > you
> > must use ir blockers ( stick on emitters)........
>
> Not if I can zone the IR off Frank and make the system I have in place a
> bit smarter.
>
> If, as I am told, that the IR can be passed back to FIRM and I can stop
> the signal being passed from there to any other zone then it solves the
> signal being blatted around the system. But, more than that, it stops
> the Sony TV in the lounge responding to IR commands sent to the Sony in
> the bedroom as both use the same IR code set.
>
> Since FIRM connects to HV via hard wire and TXs that way then it
> eliminates a lot of needless complication in that way I've done things
> and could stop conflicts/feedback.
>
> The Xantech system runs on 12V and I have the Buffalo RX units running
> the same way as Mark, only at 12V and they're fine.
>
> The emitters just go to the normal 3.5mm (I think) plug for an output to
> each zone.
>
> K.
>
>
>
>
> http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx > Subscribe:  ukha_d-subscribe@xxxxxxx > Unsubscribe:  ukha_d-unsubscribe@xxxxxxx > List owner:  ukha_d-owner@xxxxxxx >
> List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>


Yahoo! Groups Sponsor
ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.