Re: Thank You James! - New Pics

["Frank Mc Alinden" <armagh@xxxxxxx>]

Hi Mark
            What im
trying to do is get some wiring info of the Receivers
and if  people were interested , was make an interface board so that
the
receivers could connect to the FirM controller  and give them zoned
Rx

Just a thought

Frank

----- Original Message -----
From: "Mark McCall" <Mark@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Tuesday, October 22, 2002 7:56 PM
Subject: Re: [ukha_d] Thank You James! - New Pics


> > Are the Xantech Receivers connected via cat5 + rj45
sockets...???
>
> The RXs are mounted into blank faceplates in wall boxes...wired back
to
> Krones in N0.  The Output side of the Xantech amplified block
goes into
the
> patch panel then out of an RJ45 at the equipment in AV Room. 
Will take
pics
> of it all soon.
>
> >  if so any diagrams???
>
> This is a rough idea of what we did...
> http://www.automatedhome.co.uk/images/temp/ir_plan.gif
>
> M.
>
>
>
>
>
>
>
> http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.