RE: IR Distribution - Problem?

["Ben McCormack" <ben.mccormack@xxxxxxx>]

Mark

I have been thinking about this one and I would just make it so that
the
DigiBox and TiVo can only accept IR from the Xantech emitters and not
>from
through a single point, allowing you to monitor the status at a later
date. (ie you could tell if TiVo has been turned on in the last 15
min).

Regards

Ben

-----Original Message-----
From: Mark McCall [mailto:Mark@xxxxxxx] 
Sent: 18 October 2002 10:19
To: ukha_d@xxxxxxx
Subject: [ukha_d] IR Distribution - Problem?


James and I have started the IR distribution through the house. 
The
amplified block will live in N0. It will be fed from Rx in several
rooms
and it will send its output to the AV room (TiVo and DigiBox).

Now - if I have Rx in the AV Room as well (so I can send IR to HV in
N0)
I assume a "normal" message to DigiBox will get there straight
from the
remote, then get there a 2nd time thru the Xantech setup?

If this is the case - is the best cure to simply make the DigiBox abd
TiVo unable to receive and direct IR by taping over the mini-emmitters?

Anyone do this or solved this problem any other way?

Thanks

M.




http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here -
http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.