The "Loop" terminal should be just a terminal connected to
nothing where you
can join a couple of wires together.
Verify the above with a multimeter.
HTH
Keith
-----Original Message-----
From: Brian G. Reynolds [mailto:brian.g.reynolds@xxxxxxx]
Sent: 12 October 2002 17:52
To: Ukha_D (E-mail)
Subject: [ukha_d] Clipsal
Hi all, just installing some lighting wiring to DIN rails and come across
a
problem...
I was going to use momentary switches to the DIN modules but I have a
2-way
stairs lights which I was going to remove and replace both cable runs
with
1mm mains cable but now I am undertaking the work I notice the clipsal
PTM
switches have 4 connections, so now I am not sure if I need to replace
the
original cable?
I was going to connect the cable to the 1 and centre connectors but as
there
is a 2 and loop I am sure I can connect the 2-way cable to this some
how?
Can anyone advise me or point me towards a wiring diagram for this
please?
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.