Clipsal

["Brian G. Reynolds" <brian.g.reynolds@xxxxxxx>]

Hi all, just installing some lighting wiring to DIN rails and come across a
problem...

I was going to use momentary switches to the DIN modules but I have a 2-way
stairs lights which I was going to remove and replace both cable runs with
1mm mains cable but now I am undertaking the work I notice the clipsal PTM
switches have 4 connections, so now I am not sure if I need to replace the
original cable?

I was going to connect the cable to the 1 and centre connectors but as
there is a 2 and loop I am sure I can connect the 2-way cable to this some
how?

Can anyone advise me or point me towards a wiring diagram for this
please?

Thanks all,

B.

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.