Re: (unknown)

["Dan" <dtoma@xxxxxxx>]

Hi,

Better you can use a RF modulator with pass-trough connector, or even
something like the VCR RF modulator. When is switched to video IN then you
can modulate the signal from the PC.
Then you can daisy-chain all of them. Just keep in mind to be on separate
channels.

Another solution is to mix the signal using a special RF mixer, but if it
is a passive one, then you will loose from the signal power.

BR,
Dan
  ----- Original Message ----- 
  From: letsfoweysome 
  To: ukha_d@xxxxxxx 
  Sent: Tuesday, October 08, 2002 2:06 PM
  Subject: [ukha_d] (unknown)


  I have got my main TV, WinTv card and a second TV daisy chained 
  together with coax.  What I would like to do is now also add
the PC 
  signal output through an RF Modulator into the system. Can I do this
  using a few Y-connectors and an inline amplifier as per below
???

  Roof Aeiral IN (actually CCTV) -
  Y Connector -
  1st TV and to PC -
  Y Connector and inline RF Modulator to add video signal - 
  Onto Final TV

  If it does work I presume I will need to use Keiths channel guide to
  make sure the new channel RF does not conflict.

  The ultimate aim is to have homseer status page on one channel, CCTV
  on an additional channel and TiVo on a third channel.




  http://www.automatedhome.co.uk
  Post message: ukha_d@xxxxxxx 
  Subscribe:  ukha_d-subscribe@xxxxxxx 
  Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
  List owner:  ukha_d-owner@xxxxxxx
  List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.


[Non-text portions of this message have been removed]



http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.