Just in case you remember my name from a
previous
posting, I was the chap having some trouble in deciding whether to go for
something like homeseer/cm12u or homevision - well I went for homevision
and so
far I haven't really done much with it - x10 stuff can be quite expensive
to
accumulate!
Any way, my first project is to do the
"movement in
the hall - lights on" thing and I heard some comment that the wireless
X10
PIR/transceiver set up presents a bit of a lag in terms of response times -
is
this true? To cut a long story short and since I have HV with all of it IO
capabilities I bought a relatively inexpensive
response systems wired PIR - trouble is there are no installation guide and
I'm
a bit of an electronics novice - please please help.
The PIR is a 12v unit so I found a 12v PSU and
connected it the appropriate terminals - its seems to flash when there's
movement so I guess so far so good. I was assuming that I should now
connect the
N/C terminals to port B on the HV to pin and ground - Am I right - HV''s a
bit
pricey and I don't want to try it and fry it. Any help
appreciated.
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.