Re: Modification of Mini Timers

["Les" <les@xxxxxxx>]

where and how have you joined the new switch wires onto the PCB. 

> The cable I used was chopped up Cat-5.  Timer PCB's went into a
plastic box with
> switch cables running out to a small terminal block.  I then ran
Cat-5 from the
> two locations each of which had a set of momentary push buttons 
matching the
> buttons on the timer on a double gang blanking plate.
> 
> 
> HTH
> 
> 
> Mark

Yahoo! Groups Sponsor

ADVERTISEMENT

http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.