RE: Splitting Inputs

["Rob Mouser" <rmouser@xxxxxxx>]

Thats ideal! Little 'y' splitters it is then!

Thanks Keith!

-----Original Message-----
From: Keith Doxey [mailto:lists.diyha@xxxxxxx]
Sent: 15 May 2002 09:14
To: ukha_d@xxxxxxx Subject: RE: [ukha_d] Splitting Inputs


Hi Rob,

The output impedance of most modern equipment is very low
The input impedance of most amps is quite high.
This means you can paralle them with no problems whatsoever.

The only things you cant easily parallel are video signal but even that
is possible if you use a distributuion amp or can remove the 75 ohm
termination from all but one of the inputs.

Keith

www.diyha.co.uk
www.kat5.tv


-----Original Message-----
From: Rob Mouser [mailto:rmouser@xxxxxxx]
Sent: 15 May 2002 08:21
To: ukha_d@xxxxxxx Subject: RE: [ukha_d] Splitting Inputs


Hi Keith

Yes they are fully remote.

If any ones interested they are Sherwood AX 4103R from Richer Sounds at
=A3149 each, although not the last word in audiophile standards it is one of the few amps I could find with IR switchable speaker A/B select and
IR everything else for that matter. I demo'd one next to my beloved
Arcam Alpha 5 (Old now but I still love the sound pumped through my
TDL's, kinda like an old pair of slippers!) and although not as good
more than acceptable for a multi-room environment.

Sorry Keith, back to your point. Hadn't considered 'Y' splitters because I guessed that their would be a loss in sound quality and possible noise problems, am I woofing up the wrong twig?

Got my eyes on your KAT5 boxes as I am considering still having my Alpha 5 in the living room. In your opinion would splitting three ways cause
problems?

Look forward to your reply.

Rob

-----Original Message-----
From: Keith Doxey [mailto:lists.diyha@xxxxxxx]
Sent: 14 May 2002 22:29
To: ukha_d@xxxxxxx Subject: RE: [ukha_d] Splitting Inputs


Rob,

You say the amps have remotely switchable speakers, is the source
selection also remotely controlable on each amp ?

If so you can simply parallel the inputs using Y splitters.

If the amps are remote from the sources, a single set of Audio only
KAT5's will allow you to send 2 sources to the amp location and connect
them to different inputs on the amps.



Keith

www.diyha.co.uk
www.kat5.tv


-----Original Message-----
From: Rob Mouser [mailto:rmouser@xxxxxxx]
Sent: 14 May 2002 10:10
To: Ukha (E-mail)
Subject: [ukha_d] Splitting Inputs


Hi

I am setting up a multi-room Hi-Fi at my new pad and after much
buggering around am going to run two amps at a central location which in turn will power two sets of speakers, the amps two speaker outs are
remote switchable so in effect I will have four independent zones of
audio (Albeit though from only one source.). I am doing it this way
because I want the audio to be discreet (Ceiling mounted Kef speakers)
and all the gubbins at a central location.

What I am going to need though is a way of splitting my input (CD,
Minidisk and Digital Source) across two (and possibly three in the
future) amps. Is a custom build from Keith at Kat5.tv is the answer with some v.short patch leads? If I could find a hi-fi separate size splitter that would be even better. Remember it would need to be a permanent
split not a switched splitter. HAVING SAID THAT if their was a remote
controllable switchable splitter I could have multi zone and multi
source!!!.....drool!

Thanks in advance.

Rob



For more information: http://www= .automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/te= rms/



For more information: http://www= .automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/te= rms/

Yahoo! Groups Spons= or

ADVERTISEMENT

<= b>Height:	4 5 6 7  ft = 0 1 2 3 4 5 6 7 8 9 10 11 in
We= ight:
Sex:	F M

For more information: http://www=
.automatedhome.co.uk 
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.