Re: Cabling Question

["Tony T" <home@xxxxxxx>]

Keith,

Thanks.
Tony T

----- Original Message -----
From: "Keith Doxey" <lists.diyha@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Saturday, May 04, 2002 1:20 PM
Subject: RE: [ukha_d] Cabling Question


Hi Tony,

You MUST NOT put the two cables into the same box so I assume you are
fitting a twin box.

This MUST have a physical barrier between the two halves or you must
used
two single boxes.

Feed the cables down in two chases and use the holes on the outside edges
of
the boxes eg

  
              
  
              
  
              
  ---------  ----------
          
         
     LV     MAINS   
          
         
          
         
  ---------  ----------

I doubt you will suffer any interference but so long as you use conduit
you
can always pull the cable out and replace it should you get problems.
You
are only talking about a 4 fot drop anyway so its not like the cables
are
running side by side for hundereds of feet.

Keith

www.diyha.co.uk
www.kat5.tv


-----Original Message-----
From: Tony T [mailto:home@xxxxxxx]
Sent: 04 May 2002 13:04
To: ukha_d@xxxxxxx
Subject: Re: [ukha_d] Cabling Question


Hi Keith,

thanks for that info, do you know of anything I could use to shield the
5v
cable? or is the whole idea a non-starter?

I can make do without the ir receivers going down the wall, but I'd
really
like to have the switches.
A 5v cable switch attached to a VIOM module attached to the ha PC is
going
to control the AD10/LD11 lights (thereby giving me a known status of
the
lights when operated manually).
The 240v switch is a backup to give manual control of the units if the
ha
system fails (and probably required to comply to some regulation or
other?).

Many thanks
Tony T



      Yahoo! Groups Sponsor
           
ADVERTISEMENT




For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Yahoo! Groups Sponsor

ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.