The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: OT: Cheap USB > 9pin Serial


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Silly question....



Guys, thanks for the responses!

Stupid of me I know but I never gave it a thought to use a meter and
test the connections! I am definitely loosing the plot on brains....

All the help makes sense now I have used the meter, I think I was a bit
worried as there are more connections than I expected.

As these switches are used just for switching(?) I assume they do not
carry any large(ish) current so I assume I can use thin wire for the
connection? i.e. 1mm square T&E with out the earth?

That is a lot of assumptions!

Thanks again all.

B.

-----Original Message-----
From: Mark Hetherington [mailto:mark.egroups@xxxxxxx]
Sent: 03 May 2002 22:42
To: ukha_d@xxxxxxx
Subject: RE: [ukha_d] Silly question....


> Hi, I have just decided to try and wire up a couple of DIN modules
using
> 2 clipsal switches.
>
> I have 1 on/off switch and 1 momentary switch. The problem is they
have
> too many connections!
>
> The switch has 3 connectors:-
> C	Common?
> 1	Phase?
> 2	Neutral?
>
> If this is correct how do I connect it to the LD11?
>
> Also the momentary switch has 4 connections.
> I assume 2 are "press to make" or "press to
break"? but what about the
> others?

My clipsal switches for DIN modules are all momentary and just wired as
Live
and Switched Live to C and 1. One exception (2-way landing light) where
I
used 2 for the "second live" (I forget the technical term if one
exists
for
the extra live in 2-way apps) but more to keep it tidy than to actually
implement two way lighting since I don't actually need the second live
any
more.

> Can anyone help me with this please as I do not know where to look?
>
> Lastly, what is the difference between an LD10 and an LD11? please do
> not say 1!.........assuming there is a difference.

IIRC the differences are Memory DIM and improved reliability. Not sure
if
"Soft Start" came in with the LD10 or LD11.

I did a doc after my installation but I can't find it. If you don't
manage
to get any further, let me know and I will try and find it on backup. I
can
also charge up the digital camera to take some pics of the installed
switches if that would help.

HTH,
Mark.



Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.