Silly question....

["Brian Reynolds" <brian.g.reynolds@xxxxxxx>]

Hi, I have just decided to try and wire up a couple of DIN modules
using
2 clipsal switches.

I have 1 on/off switch and 1 momentary switch. The problem is they have
too many connections!

The switch has 3 connectors:-
C      Common?
1      Phase?
2      Neutral?

If this is correct how do I connect it to the LD11?

Also the momentary switch has 4 connections.
I assume 2 are "press to make" or "press to break"? but
what about the
others?

Can anyone help me with this please as I do not know where to look?

Lastly, what is the difference between an LD10 and an LD11? please do
not say 1!.........assuming there is a difference.

TIA,

B.

Yahoo! Groups Sponsor

ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.