The comfort protocol is available in the tech area of the comfort
site.
At 20:45 21/03/2002 +0000, you wrote:
I've just linked up HomeVision
(additional serial port) directly to
Comfort (second UCM01/A). This is in addition to both Comfort and HV
being connected to a PC running ACE and HV software. I'm trying to
get them to talk to each other directly (therefore bypassing weakest
link of PC) for a few critical links (Comfort has control of PIR's
but HV will also use these for light switching).
I did read something a few months ago about the serial commands
involved, hint/tips etc. Anyone done this or seen any detailed notes
on linking these two together.
Might save me a few hours experimentation :)
Paul.
Yahoo! Groups Sponsor
ADVERTISEMENT
For more information:
http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.