The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Re: OT Adjusting Home cinema - equalizer


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: Re: OT Adjusting Home cinema - equalizer
  • From: "Nikola Kasic" <nikola@xxxxxxx>
  • Date: Wed, 29 May 2002 13:40:12 +0100
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Yes, it's a pink noise that I used for adjusting levels.
I don't know what kind of noise was on those frequencies, but I think it was also pink noise.
There are also signals on that DVD for rattle test.
One goes through whole spectrum 20Hz-20kHz.
The others are 5 chunks of that spectrum, I forgot what the borders of each exactly are, but I can check.
If, for instance, I put one of those chunks to play constantly and measure SPL, and then go through each of them and repeat, will I get 5 points on a frequency response chart so I can make a graph. I know that it's not accurate, just 5 points, but my equalizer is also not perfect. I have an option to change gain on 3 freqencies only.
Nik
-----Original Message-----
From: librashagger [mailto:jerome@xxxxxxx]
Sent: 29 May 2002 13:17
To: ukha_d@xxxxxxxSubject: [ukha_d] Re: OT Adjusting Home cinema - equalizer

--- In ukha_d@y..., "Nikola Kasic" <nikola@k...> wrote:
> I played yesterday with Sound Pressure Level meter and Test
DVD (Ultimate
> DVD Platinum) and it just confirmed what I knew that my
system is not
> reproducing signal in mid ranges so I need to increase it with
built in

The only way to properly do this is with a spectrum analyser, pink
noise and a flat response microphone.   Your SPL meter will
quite possibly be inaccurate if you're listening to different
frequencies of tone seperately.  We have our dubbing theatres
lined up by Dolby every now & then, and though a Tandy SPL
meter is fine for quick level measurements (with pink noise), a
proper spectrum analyser is needed, with a microphone with a
very flat response, to adjust the eq.

Is  there pink noise on the test DVD? Perhaps a PC spectrum
analyser prog could be found too.  Dolby obviously use veh veh
expensive flash analysis equipment for this task.

Jerome



For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.