RE: Lighting Control -------- IS TIM THERE?

["Hawes,Timothy Edward (GEG)" <haweste@xxxxxxx>]

I think Ken was referring to Tim Morris. He's been looking at the
Clipsal
system (amongst others) - very nice. Basically this is Cat5 to all
switches
and the lighting (mains) circuits home-run to the Clipsal
"panel". 

Cheers,

Tim H.

-----Original Message-----
From: Rob Mouser 
Subject: [ukha_d] Lighting Control -------- IS TIM THERE?


Hi Tim

See below, can you help?

Rob

-----Original Message-----
From: Kenneth Watt
Subject: RE: [ukha_d] Lighting Control


If you can afford it hard wired is better, talk to Tim as he did a lot
of research on this just recently.

K.

> -----Original Message-----
> From: Rob Mouser [mailto:rmouser@xxxxxxx]
> Sent: 24 May 2002 09:41
> To: Ukha (E-mail)
> Subject: [ukha_d] Lighting Control
> 
> Dear All
> 
> Well I've finally got my whole house audio sorted for the new barn,
so
> now its on to Project 'B' - Lighting. the problem is I'm a little
torn
> between which way to go?
> 
> I've got a few options, the barn has been wired with two system
> circuits, the main lighting circuit is on a standard system but to
aid
> the automation process I've had neutral feeds placed back to every
> switch. Secondly I have various runs of cable that  feed various
zones
> all coming back to a dedicated consumer unit so I can use X10 Din
Rail
> modules or a dedicated lighting system such as Lutron or Polaron.
> 
> So which way do I go? Lutron style zoned dimming control or X10 or
a
> combination of the both? The majority of all automation control is
via
> Xantech IR receivers placed in each room. I have to say I'm a bit
put
> off by X10 because of the negative posts I've seen regarding stray
> signals, erratic behaviour, fuse blowing etc?
> 
> What are peoples comments, suggestions, recommendations?
> 
> Also as a side; Lutron units use something called Pelv wiring for
> controller linking. Is Shielded CAT5, to the Pelv standard? Also
what
is
> the safe voltage CAT5 can take, for relay switching etc (Curtain
control
> etc)?
> 
> Thanks
> 
> Rob
> 
> ------------------------ Yahoo! Groups Sponsor
> 
> For more information: http://www.automatedhome.co.uk
<http://www.automatedhome.co.uk>
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
> 
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
<http://docs.yahoo.com/info/terms/>
>