DIY 19" Rack Photos

["Hawes,Timothy Edward (GEG)" <haweste@xxxxxxx>]

A little while ago I promised to firstly finish, then photograph my DIY
rack.

It's more or less complete. It needs a top & bottom, plus the castors
fitting but it's just about there. All I need now are some "bargains" (c) to
populate it with ;-)

I apologise in advance for the photos, they were taken about 9.30 last
night, on a DV camcorder without a flash, so they are bit grainy. You get
the idea though. I'll take some better ones with a view to writing this up
as a tutorial, if there's sufficient interest.

The frame is made from two metal-framed tables one on top of the other, cut
down to size and joined with blocks inside the tubing. Overall approx dims
are: 1225h x 580w x 570d

For my fellow skin-flints, the total cost was about 50p for a couple-dozen
screws, everything else came from a very generous skip (yup, that includes
the 3U case :-) )

The pictures are in the photos section of the group on Yahoo, see:
http://photos.groups.yahoo.com/group/ukha_d/lst?.dir=/Tim_Hawes/DIY+19in+Rac
k&.src="gr&.view=t

Cheers,

Tim H.

+

Yahoo! Groups Sponsor

ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.