The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

HV RX UPDATE


  • To: <ukha_d@xxxxxxx>
  • Subject: HV RX UPDATE
  • From: "Frank Mc Alinden" <armagh@xxxxxxx>
  • Date: Sun, 30 Jun 2002 14:40:14 +1000
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Hi All
        Well my hv ir reciever progress was short lived. I cant get hv to correctly recognise which rx is active. When a (stored) ir signal is recieved Homevision scans the ir active mux and should detect the active rx. I tried all sorts but no luck . I also think now the design is flawed as the ir active signal is only present for approx 1 second ,if hv is busy the active signal may be gone when hv does get round to scanning the rx mux...
    What happens when hv recieves an ir signal while say transmitting an X10 signal? Does the ir signal not get detected?
 
Im now thinking of using  a Pic to detect which rx is active and using 3 i/o pins as outputs to identify the active rx . Homevision when ready reads the status of  its 3 inputs (connected to ir rx outputs) and determines which rx is active then pulses a hv output to ACKnoweldge(connected to a Pic input pin)  that it has decoded the Pics mux outputs . So 4 i/0 pins would be required on hv....
 
I was also thinking of adding an RS232 port to the Pic so that ir active data could be sent say to a pc. Can the Girder Software talk to more than one serial port?
 
Any comments/ideas
 
Frank Mc

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.