The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: RE: Re: Silent 10/100 rackmount switch?


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: TTL SPDIF -> TOSLINK


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: TTL SPDIF -> TOSLINK
  • From: "Keyvan Rahimian" <keyvan@xxxxxxx>
  • Date: Thu, 27 Jun 2002 21:39:01 +0100
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Take a look at this...
 
There is a switching unit too (see previous message)
 
The US site with more data and manuals is
 
I am also looking at using more digital sources / switching. If only I could get the right cable to connect my SB Audigy digital out to the digital input on my Denon amp... :-(
 
Any ideas ???
KR
-----Original Message-----
From: Mark Marooth [mailto:MMarooth@xxxxxxx]
Sent: 26 June 2002 16:11
To: ukha_d@xxxxxxxSubject: [ukha_d] TTL SPDIF -> TOSLINK



I've come across a couple of circuits which use Sharp/Toshiba TOSLINK modules to
take the TTL SPDIF output from a CD-ROM drive and output as Optical, has anyone
else
had any experience with these modules or are there any suggestions for pre-built
devices to do the same.


What I want to do is this:

As an adjunct to my Whole House Audio plans which comprise Veronica FM
Transmitter hooked up to MP3 Juke and FM Receivers around the house, I want to
distribute a higher quality  signal to a couple of rooms.

What I need to know is what is the 'practical' optical fibre length before the
signal needs to be re-amplified.  I worked on a secure fibre optic network in Oz
years ago and I know that that fibre ran for miles between repeaters, would the
same apply with TOSLINK ?

I'm assuming that most sound cards will have  a digital TTL source somewhere
other than perhaps older cards so it should be no problem to lift the Digital
TTL signal and convert to TOSLINK thus doing away with the DAC and the analogue
output.

I'm also thinking that if this idea is a goer, it should not be that difficult
to build a TOSLINK distribution box i.e. 1 optical input and say 8 optical
outputs.


Anyone got any thoughts, am I wasting my time, has it all been done before ?



Cheers,


Mark

New Veronica arrives today !




For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.