The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Re: (OT) Ceiling joist spacing


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: Re: (OT) Ceiling joist spacing
  • From: "Des Gibbons" <des@xxxxxxx>
  • Date: Wed, 23 Jan 2002 22:41:27 -0000
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

Can I just add to make sure the bit you hold is insulated if you have no
idea what is in there ;)

Des

> -----Original Message-----
> From: Steve Cooper [mailto:steve.cooper@xxxxxxx]
> Sent: Tuesday, January 22, 2002 16:57
> To: ukha_d@xxxxxxx
> Subject: Re: [ukha_d] Re: (OT) Ceiling joist spacing
>
>
>
> If you are going to drill a small hole you can could use another
method.
>
> - Get a piece of fairly stiff piece of wire and bend it at right
angles.
> - Stick a pencil eraser on one end so that it point the same way as
the
> bend.
> - Slide the wire up into the cavity at a slight angle until the whole
of
> the bent bit is in the roof.
> - Then twist it round like you would with a TV aerial trying to get
the
> reception right.

>
>



Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.