Learning Comfort (success!) and X10 Signal blocked

["Gareth Cook" <gcook@xxxxxxx>]

Thanks to everyone on this list who
helped me come to grips with Comfort programming, esp. Michael McAree, and
 - I've now managed to alter the system so that each sensor/PIR send
out a unique X10 command, so I can pick it up with HomeSeer and action from
there. Except that....

The only problem I've encountered is
that in my Node 0 (
http://quickplaceuk.lotus.com/QuickPlace/garethcook/Main.nsf/h_Toc/E2B1151595CEA78980256A15006256CC?OpenDocument
), no X10 signals are leaving for the rest of the house - so it looks like
I may need to do some detective work, and maybe have to buy a filter -
assuming it IS an appliance and not the spur that is causing the problem.
If I plug in the Infrared to X10 unit, that can't send signals out
either.

When I plug an appliance module in next
to Comfort, the "lamp" does come on - so I know I've done the
codes correctly in Comfort.

I've put a little diagram of my x10
system up at my website (http://garethcook.com , click on X10 Layout at the
bottom) - it's simplified but shows the necessary information.

G.

Gareth Cook Senior Engineering Specialist EMEA ED, IBM SWG Lotus Park, Staines, TW18 3AG

Office:  +44 (0) 1784 445 166 Mobile:  +44 (0) 7980 445 166 Fax:      +44 (0) 1784 499 166

Work: g@xxxxxxx Personal: g@xxxxxxx AIM Chat : TheBoyG MSN Chat : chat@xxxxxxx

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.