The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024

Latest message you have seen: Re: [OT] Mac advice...


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: RE: Dim to 0%



I have these plugged in under the bed, and don't want to rewire the room!!
 
Now if they built one in a plug in module then I'd be away!! :-)
 
Instead, I'm going to go down the waste a bit of electric route. - but to minimise this (it is minimal anyway), I'm going to run an event in homeseer to do the following:
 
If we are at home:
Turn off the lamp at 8am.
Turn on the lamp at 8pm and dim it to 0%
 
That way I cut out 12 hours of it sat on all the time.
 
Daniel
-----Original Message-----
From: adrian.lucas@xxxxxxx [mailto:adrian.lucas@xxxxxxx]
Sent: 17 January 2002 15:31
To: ukha_d@xxxxxxxSubject: [ukha_d] RE: Dim to 0%


If you can use a LD10 (DIN rail dimmer) instead of an LM then when you send ON it comes on at the brightness it was at when you turned it off.

HTH
Adrian

> If you have sent the command "Off" to the LM, next time you turn it on, to
> for example a 30% preset dim, X10 sends the module the command "On" first
> and then Dim to X% - so the light comes on bright and then dims down.

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.


***********************************************************
This message is confidential and intended for the exclusive
use of the addressee(s) only and remains the property of
Exchange FS Group plc. You should not disclose its contents
to any other person. If you are not the intended recipient
please notify the sender named above immediately.

Registered Office: Munro House, Portsmouth Road, Cobham,
Surrey, KT11 1TE. Registered in England No. 2596452
***********************************************************

Yahoo! Groups Sponsor
ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.