----- Original Message -----
Sent: Sunday, February 24, 2002 10:42
PM
Subject: RE: [ukha_d] [OT]Kodak
Dont
have a Kodak but the temperature error sounds familiar.
One
of my old Nokia phones used to say it was fully charged after about 10
minutes
when I knew it needed an hour. This always happened when it was very flat
and
the phone was cold and I was using the car charger.
disconnecting it and reconnecting restored normal
operation.
Keith
Alan,
I
had 4 cameras and had the same problem with all of them. I sorted it
by:
Charging for 2 hours, keeping an eye to ensure the green light does
NOT come on within the two hours, (if this happens lift the camera, and
replace on the dock)
Use the camera with the screen on, and flash, and keep snapping till
the batts are flat, and the camera turns off.
Repeat step 1.
This SHOULD fix your problem. Like I said, it worked for all
mine.
The red flashing light means:
Battery Pack is installed incorrectly. |
Reinstall the Battery Pack (Installing
the Battery Pack in the Camera). |
Incorrect battery type |
Charge only a rechargeable battery. |
The Battery Pack or connector pins are damaged. |
Check for damage. |
The camera and Battery Pack have been exposed to very high or low
temperatures. |
Slowly return the camera and Battery Pack to room
temperature. |
The EASYSHARE Camera Dock insert not properly installed. |
Insert the Dock insert correctly (Installing
the Dock Insert). |
I
found that its usually the last one. Try lifting and
re-seating.
You could also try removing and reinserting the battery
pack.
HTH