RE: CM12U timed macro problem!

["Kenneth Watt" <kennwatt@xxxxxxx>]

Bazza,

Off a standard LM10, lamp module, the light will start at 100% then dim
to the set level, not brighten from off.

To do what you are asking here you will need to do some programming to
get the module to operate at night the way you want. I tried using the
software that came with a CM12 at one point but, personally, I thought
it was a bit pants as I use HomeVision as my controller. A lot of the
guys use HomeSeer and they all rate it so you could have a go at the
trial version of that and see how you go, you can find it here:
http://www.homeseer.com/

What you want to do is tell the software that if it's night and the PIR
is activated then to switch on the lamp and set to whatever level,
fairly simple.

K.

> -----Original Message-----
> From: Bazza [mailto:bazza2000@xxxxxxx]
> Sent: 22 February 2002 08:23
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] CM12U timed macro problem!
>
> Hi,
>
> I've just bought a CM12U computer interface and a
> couple of lamp modules.  What I want to do it use a
> PIR detector (MS13E) to allow me turn on the lights
> when the detector is activated.  However, I only want
> the light to be activate between the hours of midnight
> and 6am.
> i.e. if I get up in the middle of the night, I want a
> macro to initiate that will brighten the lamp modules
> by 50% so that I don't completely wake up and yet I
> can see where I'm going.
> I know there is dawn and dusk setting to only initiate
> the trigger when its dark, but I don't want the lamps
> to come on if I walk past them before I go to bed.
>
> Any ideas would be appreciated,
> I know this can be done with heyu and extend, however,
> I don't have a PC that is left on all year round, so I
> need to functionality from the CM12U unit, or possibly
> another one?
>
> Thanks in advance,
>
> Bazza.
>
>
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Sports - Coverage of the 2002 Olympic Games
> http://sports.yahoo.com
>
> ------------------------ Yahoo! Groups Sponsor
>
> For more information: http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
>




_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com