RE: The key things about the DDAR/Rio patch

["Kenneth Watt" <kennwatt@xxxxxxx>]

Nope, done all that...still nada

K.

> -----Original Message-----
> From: mark_harrison_uk1 [mailto:Mark.Harrison@xxxxxxx]
> Sent: 09 February 2002 20:03
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] The key things about the DDAR/Rio patch
>
> I too had problems doing this, this is what I learnt:
>
> 1: Don't try to do this unless you're starting with the (PC) software
> that contains receiver.arf. If you have an older version with
> the "something else".arf then get and install the _full_ new
version
> first! (If you need a copy, mail me off-list.)
>
> 2: You then need to down load the arf-merger utility AND the receiver
> patch and merge them as per the instructions in the README on empeg's
> site.
>
> 3: The receiver.arf you finish up with should be 6.85 Mb (ie the size
> that Stuart and I got).
>
> 4: Once you've installed the new receiver.arf and restarted the (PC)
> server software, you need to HARD reboot the DDAR (ie - pull out the
> power cable), not just press the on-off button.
>
> 5: When you hard reboot, you need to keep the power cable about for
> about 5-10 seconds to actually reboot. Otherwise there's enough power
> left in the capacitors to keep it alive!
>
> 6: Finally, if you have more than one receiver, then you'll need to
> re-check which IP is which after the installation of the new
> receiver.arf
>
> Hope this helps.
>
> Mark
> *not watching Pop Idol*
>
>
>
> ------------------------ Yahoo! Groups Sponsor
>
> For more information: http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/
>