|
Okay,
just now, I use an AM10 for the K400, and do the switch off, wait a
minute,
switch on again trick to toggle the curtains. obviouslly, it would be much
nicer
to have a discrete Open or Close.
Reading this, I think that I could power
the
curtains all the time, directly from a wall socket, and use a 240V
relay
with one Normally Closed and one Normally Open Contact, plugged into the
AM10,
and wire it so that when the module is powered, "Common" is connected
(through
the Normally Open contact) to the "Open" Command Line and when the module
is
turned off, the Common is then connected (through the Normally Closed) to
the
"Close" Command Line...
In
this case, I would think you could simply use the AM10 so that switching on
opens the curtains, and off closes them?
Any
problems with this ?
Ian.
Here it is
Alancc
----- Original Message -----
Sent: Friday, February 15, 2002 11:11
AM
Subject: [ukha_d] Swish K400
control
One
of
the connectors has control lines. IIRC you connect the "open"
line to common (using switch or relay) to initiate open and similarly for
close. I have the details at home so can post on Monday if
required.
Adrian
> >
Somebody posted recently about getting the K400 motor to do
discrete
> > open and close movements rather than just operation via
toggle
switch.
> >
> > Sorry to be a pain but can't find
the
thread on yahoo, can
someone
> > let me know how this is
achieved
> >
> > Regards
> >
> >
Paul
For
more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:
ukha_d-subscribe@xxxxxxx
Unsubscribe:
ukha_d-unsubscribe@xxxxxxx
List owner:
ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is
subject to the Yahoo! Terms of
Service.
| Yahoo! Groups
Sponsor |
ADVERTISEMENT
;) |
|
|
For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
|