As Tim suggesets it would probably be easy to take an existing handset
apar=
t
and put it to a new use. The Mic and speaker would have seperate leads
to
the main unit, the keypad would depend upon construction, however a bit
of<=
BR>
careful butchering would probably give you the bits you needed.
These guys sell end of line and customer returns products, so you could
pic=
k
up a handset for around =A340.
-----Original Message-----
From: Christian Cundall (Groups) [mailto:groups@xxxxxxx]
Sent: 14 December 2002 09:40
To: ukha_d@xxxxxxx
Subject: [ukha_d] DECT hardware
I want to embed a telephone in another device, Does anyone know where I
can=
get the hardware that is usually inside a DECT handset from? Ideally
with
separate leads to mic, keypad and speaker.
_____________________________________________________________________
This e-mail has been scanned for viruses by the WorldCom Internet
Managed
Scanning Service - powered by MessageLabs. For further information
visithttp://www.worldcom.com
_____________________________________________________________________
This e-mail has been scanned for viruses by the WorldCom Internet Managed
S=
canning Service - powered by MessageLabs. For further information visit http://www.worldcom.com
Comments to the Webmaster are always welcomed, please use
this contact form
. Note that as this site is a mailing list archive, the Webmaster has no control
over the contents of the messages. Comments about message content should be directed
to the relevant mailing list.