RE: Kinetic Colour Cove lights - wiring question

["Bricknell, Tony" <tony.bricknell@xxxxxxx>]

The Red and Black wires are for 24Vdc power - rather conventionally
colored
(sic) Red:+24V Black:0V
The third (blue) wire is for DMX control.  Roll on Ian's PIC
controller with
programmable colourwash, etc....

As for cable type - as long as it can take the current consumption
(which,
going on distant memory, is circa 0.3A each) then yes, mains flex is
fine.

HTH

-----Original Message-----
From: Gareth Cook [mailto:g@xxxxxxx]
Sent: 14 December, 2002 18:05
To: ukha_d@xxxxxxx
Subject: [ukha_d] Kinetic Colour Cove lights - wiring question


On the actual cove lights themselves they are three cables - and all the
diagrams I can see only mention plugging in two - but not which ones !

Can anyone enlighten me as to which two I should be connecting to the PSU
module ? And is using standard 3way mains flex ok ?

Thanks !

G.


http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx 
Subscribe:  ukha_d-subscribe@xxxxxxx 
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx 
List owner:  ukha_d-owner@xxxxxxx
List of UKHA Groups here - http://groups.yahoo.com/group/UKHA_Grouplists/

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.