|
The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024
|
Latest message you have seen: RE: Re: iPaqs and 802.11b |
[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
RE: X10/Room Occupancy/SWMBO acceptance
> Not sure about your exact solution, but I will outline my
> setup. I have
> 3 lights in the bedroom - 2 bedside lights and the main light. When
we
That's what we have.
> go to bed 'bedtime' is run from Homeseer. This macro
How do you run this? Do you press a key on a pronto or something?
I don't really want to have to do this - not SWMBO friendly.
> Now your situation is different in that your SWMBO will
> complain. Tough.
> In my setup it would be much the same if there were no X10 lights,
> except you would have to get up off your arse to turn off the main
> bedroom and landing lights. If you go to bed after SWMBO
> (without an X10
No, not tough. I don't want to a) introduce additional steps
(which seems
pointless) or b) overcomplicate things.
At the moment for example, SWMBO wants to go to bed.
She turns on the landing light, goes up stairs, into the bedroom, may or
may
not turn on the main light, turns on bedside light.
On way back to bathroom, turns out main light in bedroom.
Back in bed, she reads/watches TV until she wants to sleep, then she
turns
out the light.
When I come to bed, depending on if SWMBO is awake or not, I may or may
not
turn on a bedroom light, and I will turn off the landing light before I
retire.
This all works fine. (So why change it? Well, gotta use my PIR
for
something :-)
It would seem to me (and indeed to SWMBO) that it is a backwards step
rather
than a forwards one if the lights go off in the middle of reading
because
SWMBO forgot to wave her arm about or I come in late and do not want
to
disturb SWMBO and the lights come on blazing because the PIR detected
me.
Also, getting a blackout mask to get around this is also a step backwards
as
it was not previously needed.
I don't see the point of automating your home if you have to work your
life
around the automation rather than it fitting in you. Moreover, when
we have
guests staying, I do not want to have to give them a 1/2 hour tutorial
on
how to operate the house.
Ideally for me, a house can be operated via traditional means or via
automation and it should not a problem to mix the two - eg light on
automatically, off manually etc.
> setup running) are you not allowed to turn on any lights? Do you
wear
> night vision? It is not unreasonable to turn on a light when going
to
> bed (either with X10 or your finger!) so if SWMBO is going to wake
up
> and complain get her a blackout mask people wear when flying.
Yes I am allowed to turn on a light, but I sometimes choose not to.
At the
moment, WE are in control of what is on and when. If we do not
have
control, then the system needs to emulate what we would normally do (or
as
much as is necessary anyway).
I have often said X or Y is not compatible with my SWMBO, perhaps
painting
her as unreasonable. She is not unreasonable, she simply does not see
the
point of change for change sake, or the need to dig a remote out of
your
pocket to turn off a light when the actual real light switch is there,
just
inches from your hand.....
Thanks for your comments though - I didn't realise homeseer was so
flexible.
Did you have to write your own programs to implement this stuff, or is
it
just a case of following a few menus to set up the rules?
cheers,
Tony
********************************************************************
Visit our Internet site at http://www.rbsmarkets.com
This e-mail is intended only for the addressee named above.
As this e-mail may contain confidential or privileged information,
if you are not the named addressee, you are not authorised to
retain, read, copy or disseminate this message or any part of it.
The Royal Bank of Scotland is registered in Scotland No 90312
Registered Office: 36 St Andrew Square, Edinburgh EH2 2YB
Regulated by the Financial Services Authority
********************************************************************
Yahoo! Groups
Sponsor |
ADVERTISEMENT
|
|
For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe: ukha_d-subscribe@xxxxxxx
Unsubscribe: ukha_d-unsubscribe@xxxxxxx
List owner: ukha_d-owner@xxxxxxx
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
Home |
Main Index |
Thread Index
|
|