RE: Re: Is it me ???

["Phil Harris" <phillip.harris1@xxxxxxx>]

*grin* See...

Phil

> -----Original Message-----
> From: Keith Doxey [mailto:ukha@xxxxxxx]
> Sent: 16 October 2001 12:57
> To: ukha_d@xxxxxxx
> Subject: [ukha_d] Re: Is it me ???
>
>
> Just found this...
>
> http://www.laser.com/files/xcam2.pdf
>
> ... which identifies a use as I listed under "1 of 16"
control, that
> of selecting which camera is powered up. I still think a small switch
> to choose between
>
> "Off with <mycode> OFF"
> "Off with <any_other_myhousecode> ON"
>
> would greatly enhance the appeal.
>
> Keith
>
>
> --- In ukha_d@y..., "Keith Doxey" <ukha@d...> wrote:
> > From Mark's news page....
> >
> > "The XM11U is an X10 addressable DC adaptor that supplies
12V. The
> > adaptor will turn on if it's own address is sent an
"On" signal,
> and
> > will turn off if any On signal is sent on the same House Code,
but
> a
> > different Address (for example, if the unit is set as A2, then
> > sending A1 On will turn the adaptor off). It is not affected by
any
> > other House Code (so sending B1 On will not change the state of
the
> > XM11). Can be used to power low voltage devices, or relays."
> >
> > .... OK I can see where a controlable wall wart would be cool,
for
> > powering KAT5 Modules for instance, but WHY is the OFF control
> > achieved by sending an ON to ANY other module on that Housecode?
> >
> > At best you could achieve "1 of 16" control using a
single
> housecode
> > because any attempt to turn another PSU on would cause the others
> to
> > switch off. If you assign different housecodes to the PSU's then
> you
> > effectively lose that housecode. ie Turn the PSU on, then decide
to
> > turn the tablelamp on and the PSU goes off.
> >
> > Seems a strange method of control to me and IMHO will severely
> limit
> > its potential. Or am I wrong ?
> >
> > Keith
>
>
>
> For more information: http://www.automatedhome.co.uk
> Post message: ukha_d@xxxxxxx
> Subscribe:  ukha_d-subscribe@xxxxxxx
> Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
> List owner:  ukha_d-owner@xxxxxxx
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>


For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/