RE: DDAR

["Justin" <justin@xxxxxxx>]

You could try re-booting the DDAR server PC. That has also worked for me in
the past. God knows why!

Justin.

> -----Original Message-----
> From: Brian G. Reynolds [mailto:brian.g.reynolds@xxxxxxx]
> Sent: 11 October 2001 11:25 PM
> To: ukha_d@xxxxxxx
> Subject: RE: [ukha_d] DDAR
>
>
> Your almost the man! 1 out of 2 aint bad!
>
> 1 of the units has now got 192.168.0.19 and 1 has 192.168.0.1
> The range I have set is between xxx.xxx.xxx.180 and 200, also
> 192.168.0.1 is
> assigned to the network card from my server to the switches!
>
> Yes I do have DHCP but it is, oops just looked, is now disabled.
>
> Now got 169.254.147.197! and with DHCP off and re-plugged in and
> still will
> not play the game!
>
> Any other suggestions?
>
> B. still confused.
>
> > -----Original Message-----
> > From: Justin [mailto:justin@xxxxxxx]
> > Sent: 11 October 2001 22:27
> > To: ukha_d@xxxxxxx
> > Subject: RE: [ukha_d] DDAR
> >
> >
> > Brian,
> > do you have some sort of DHCP server on your LAN?
> > I have had similar trouble while running Win Route. It was
assigning an
> > address to the DDAR rather than the DDAR software itself. What
> I had to do
> > was disable DHCP, plug the DDAR back in (so it got its address
from the
> > correct software), then re-enable Win Route.
> >
> > Hope that helps.
> >
> > Justin.
> >
> > > -----Original Message-----
> > > From: Brian G. Reynolds [mailto:brian.g.reynolds@xxxxxxx]
> > > Sent: 11 October 2001 10:14 PM
> > > To: UKHA Group
> > > Subject: [ukha_d] DDAR
> > >
> > >
> > > OK what have I done to my DDAR's? I unplugged them both to
> check my X-10
> > > macro's and now after plugging them back in, nothing!
> > >
> > > I am sure it is an IP Config thing.
> > >
> > > I have gone into the Audio Receiver Manager/tools/ip config,
and
> > > entered the
> > > range 192.168.0.180 to 200 but the DDAR's refuse to get new
IP's, any
> > > suggestions?
> > >
> > > B.