RE: CM 12 unit locking

["Steve Morgan" <steve@xxxxxxx>]

Is there a macro firing in response to the Off event that is going into an 'infinite loop'? For example, if in response to a specific instruction, say A1 Off, the CM12 issues its own A1 Off you end up with a feedback loop that will saturate the mains with X10 signals. I've seen this happen before.

 

Steve

 

 

-----Original Message-----
From: Campbell Macdonald [mailto:c.macd@xxxxxxx]
Sent: 07 October 2001 18:18
To: ukha_d@xxxxxxxSubject: [ukha_d] CM 12 unit locking

I have set M13 for cctv switching and m13 on works fine, Unfortunately m13 off freezes up all x10 commands after switching all units off. It only works again after I unplug the cm12. This happens using a tm12 or Comfort dial in. The cm 12 has no batteries (nothing in memory).

 

anybody any ideas...apart from resetting housecode...which I may do later but will take time due to all the Comfort responses/ units etc.

 

Any help appreciated

 

Campbell

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Yahoo! Groups Sponsor

ADVERTISEMENT

For more information: http://www.automatedhome.co.uk
Post message: ukha_d@xxxxxxx
Subscribe:  ukha_d-subscribe@xxxxxxx
Unsubscribe:  ukha_d-unsubscribe@xxxxxxx
List owner:  ukha_d-owner@xxxxxxx

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.