[Date Prev][Date
Next][Thread Prev][Thread Next][Date
Index][Thread Index]
[PROJECT] More project ideas
- To: ukha_d@xxxxxxx
- Subject: [PROJECT] More project ideas
- From: "Andy Powell" <Andy@xxxxxxx>
- Date: Sun, 20 May 2001 20:37:58 +0200
- Delivered-to: rich@xxxxxxx
- Delivered-to: mailing list ukha_d@xxxxxxx
- Mailing-list: list ukha_d@xxxxxxx; contact
ukha_d-owner@xxxxxxx
- References: <TFSRRHDK@xxxxxxx>
- Reply-to: ukha_d@xxxxxxx
Ok,
well I've gone a bit mad ... I've been thinking of some projects and come
up with a list below (one of which already seems to be taking off). Most
are ethernet based ideas but there you go - you've all got loads of CAT5
running all over the house haven't you ;-)... the projects could also be
433mhz...
Here they are some are a little wild... feedback p-lease...
A.
Project Name Description
==============================================================================
001AP IREDS Ethernet to IR interface.
002AP ERDU 433mhz/Ethernet to remote LCD display.
003AP ESWITCH-AV Ethernet A/V Switcher/distribution panel.
004AP EIF-SCAL Ethernet to Sony Control-A/L.
005AP ERTM Ethernet/433mhz Temperature Monitors.
006AP EIF-PS2 Ethernet to Playstation 2 controller Interface.
007AP EGDC Ethernet Garage door controller
008AP ESER Ethernet to serial port
009AP EDACS Ethernet door access control system
010AP EFD Ethernet Fire detector
011AP EGD Ethernet Gas detector
Woooaaahh slow down there
=========================
Ethernet enabled TV, VCR, CD Player etc...
Project 001AP
=============
Ethernet <-> IR interface
IREDS - Infa Red Ethernet Distribution System (for want of a better name)
Brief ideas
===========
Receiver = Emitter unit
Each receiver has an IP address which means that Zoneing would be simply a
matter
of sending the ir data to a specific group of ip adresses. Of course you
would
actually know what piece of kit had what ir emmiter.. eg Sony CD Player, ip
address 10.21.1.3 so you could target the specific device rather that
sending
the same IR data to all emitters.
Each zone would only require 1 CAT5 connection to the main box (either a PC
or
standalone unit) because you could just install a hub or switch locally to
increase ports
PC interface in the main box to allow it to send commands to zones
Main box could use internal storage ( see http://www.milinst.com/megastor.htm
)
for learnt IR commands
Project 002AP
=============
ERDU - Ethernet Remote Display Unit
433mhz/Ethernet Remote LCD display
Uses a PC interface to send remote information to LCDs via 433mhz/Ethernet
Each Receiver has an ID via dip switches so that it can see if the
message was destined for it
Host (PC) software can broadcast to ALL screens or just specific ones.
Project 003AP
=============
ESWITCH-AV - Ethernet Enabled A/V Switcher
Brief ideas
===========
Change sources via ip
Good for use with KAT5 units
Project 004AP
=============
EIF-SCAL - Ethernet Interface to Sony Control L/A
Brief ideas
===========
None
Project 005AP
=============
ERTM - Ethernet Remote Temperature Monitor
Brief ideas
===========
Each monitor can be queried, until it is queried it simply monitors the
temperature. This revents unwanted network traffic
Project 006AP
=============
EIF-PS2 - Ethernet Interface to Sony Playstation 2 'joypad'
Brief ideas
===========
Interface the PS2 control pad so that it can be controlled remotely and
locally
Mainly for watching movies as the crap IR controller that's available is ..
well
crap.
Project 007AP
=============
EGDC - Ethernet Garage Door Controller
Brief ideas
===========
Open/close and get the status of your garage door.
Project 008AP
=============
ESER - Ethernet to serial port converter
Brief ideas
===========
Use this so that you can put standard serial devices on your network
Project 009AP
=============
EDACS - Ethernet Door Access Control System
Brief ideas
===========
Never be locked out again!
Remotely open doors etc for deliveries
Project 010AP
=============
EFD - Ethernet Fire Detection
Brief ideas
===========
Check the status of the fire/smoke detector
e.g.
Alarm condition
Low battery
Project 010AP
=============
EGD - Ethernet Gas Detection
Brief ideas
===========
Check the status of the lethal Gas detector
e.g.
Alarm condition
Low battery
--- Tag-it! v2.0 (c) Andy Powell ,1998,1999,2000...and beyond..
Absolute Zero is cool - 0K?
Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
Home |
Main Index |
Thread Index
|