Re: Remote codes for Response TV4000 switcher

["Campbell" <c.macd@xxxxxxx>]

Thanks for the "Response"... :-)

Comfort is dead easy to set up for switching using the 12v except you must
remember it is the -ve side which is being switched, +ve is continuous. As
the Response system uses a 12v supply with common earth for
audio/video/switching, be cautious.

Campbell

----- Original Message -----
From: "Chris Williams" <ccwilliams@xxxxxxx>
To: <ukha_d@xxxxxxx>
Sent: Thursday, March 22, 2001 9:26 AM
Subject: Re: [ukha_d] Remote codes for Response TV4000 switcher


> Campbell,
>
> Am I right in thinking you have a Comfort system? ( If not ignore this
> message! )
>
> I have a Comfort and a TV4000 switcher.  My cameras do not have PIR
sensors
> so I was planning to use Comfort outputs (12v) to simulate the Trigger
> signals (12v) from the cameras.  Problem is this means tapping into
the
> camera connections to the TV4000.  Once this is working you would need
to
> figure out how to get Homeseer to persuade Comfort to change camers.
> Simplest option may be X10?
>
> My biggest problem is that both the TV4000 switcher and the TV4000
modulator
> forget their settings when the power trips.  This means UHF channel
changes
> and remote no longer works.  Because both units are in the loft this
is a
> real pain.  I am hoping to arrange to power these units from Comfort
so
they
> don't loose their settings.
>
> Just some thoughts,
>
> Regards,
>
> Chris
>
> ----- Original Message -----
> From: "Campbell" <c.macd@xxxxxxx>
> To: <ukha_d@xxxxxxx>
> Sent: Wednesday, March 21, 2001 10:11 PM
> Subject: Re: [ukha_d] Remote codes for Response TV4000 switcher
>
>
> > What I want to know is how to use Homeseer to switch the response
4000
> > switcher...
> >
> > Any ideas
> >
> > Campbell
>
>
>
>
>
>
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>
>