The UK Home Automation Archive

Archive Home
Group Home
Search Archive


Advanced Search

The UKHA-ARCHIVE IS CEASING OPERATIONS 31 DEC 2024


[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: Split aircon unit, info required


  • To: <ukha_d@xxxxxxx>
  • Subject: RE: Split aircon unit, info required
  • From: "Phil Harris" <phillip.harris1@xxxxxxx>
  • Date: Tue, 26 Jun 2001 17:55:50 +0100
  • Delivered-to: rich@xxxxxxx
  • Delivered-to: mailing list ukha_d@xxxxxxx
  • Mailing-list: list ukha_d@xxxxxxx; contact ukha_d-owner@xxxxxxx
  • Reply-to: ukha_d@xxxxxxx

I'll take out half a brick when I put them into the garage (AV room) but for the time being will chop a lump out of the bottom of the patio door.
 
Phil
-----Original Message-----
From: Graham Howe [mailto:graham@xxxxxxx]
Sent: 26 June 2001 17:48
To: ukha_d@xxxxxxxSubject: RE: [ukha_d] Split aircon unit, info required

The 8cm hole is required if you want to pass the detached pipe through a wall. The other option is to leave the pipe connected and chop out a small rectangle (55x25mm) from your window frame (that's what I will do). I have never heard of an 8cm drill bit or a drill capable of driving it so I would assume it is a hammer and chisel job (i.e. knock out a few bricks and then make good afterwards) if you want to go through a wall.
 
Graham




____________________________________
Automated Home UK
http://www.automatedhome.co.uk
____________________________________


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Yahoo! Groups Sponsor
Check
out great fares at Orbitz!



____________________________________
Automated Home UK
http://www.automatedhome.co.uk
____________________________________


Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

Home | Main Index | Thread Index

Comments to the Webmaster are always welcomed, please use this contact form . Note that as this site is a mailing list archive, the Webmaster has no control over the contents of the messages. Comments about message content should be directed to the relevant mailing list.