RE: How do you wire an LD10?

["Steve Gordon" <steve@xxxxxxx>]

Mathew,

The Neutral is needed for the LD10/11.
If you are planning to mount the LD10/11 at the switch location then your
wiring is correct. If you are planning on mounting the LD10/11 near the
consumer unit you need to run a seperate cable from the switch to the
LD10/11 and from the Light position to the LD10/11.

It's all relative to where you are goingt oput the LD10/11 and the access
you have to it.

Steve

-----Original Message-----
From: matthew@xxxxxxx [mailto:matthew@xxxxxxx]
Sent: 09 June 2001 21:19
To: ukha_d@xxxxxxx
Subject: [ukha_d] How do you wire an LD10?


I'm just looking at how a "normal" light circuit is wired, with
the
connection for the switch and the loop to the next light in the
ceiling rose.

Having read somewhere on the net about some lighting controllers
needing a neutral in the switch, my electrician and I decided to wire
the light so that the connection is in the switch not the ceiling
rose.

I have one lighting circuit per room so basically the wire runs up
from the consumer unit to the switch, then there is another cable
from the switch to the ceiling rose.

I'm just wondering if this is the right way to do it, before I go
repeating this scheme for all the other lights in the house!




____________________________________
Automated Home UK
http://www.automatedhome.co.uk
____________________________________

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/







____________________________________
Automated Home UK
http://www.automatedhome.co.uk
____________________________________

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/