Stripped out the old system
Run loads of new cables
The old system was 14 years old and some of the wiring bodges have t
be
seen t be believed!!
Awaiting 2 Krone boxes from RS
Installed the crate one keypad and got the serial link
working
Comfort uses a full set of pin connections (unlike HomeVision with its RDX,TDX and
GND)
Now down t the hard bit of programming it so the alarm actually
works!
Mike
Antena
Caernarfon
-----Original
Message-----
From: Mike Griffiths
[mailto:mike@xxxxxxx]
Sent: Sat 14 July 2001
00:52
To: 'ukha_d@xxxxxxx'
Subject: RE: [ukha_d]Now
Comfort
new install was Alarm Failure
OuCH
Just finished going through the
manual
My Head hurts
I think I’ll sort the Homevision/Comfort
Link via ACE
DDEing ont the Homevision Program
I think L
Mike
Sent from Home
-----Original
Message-----
From: Mike Griffiths
[mailto:mike@xxxxxxx]
Sent: Fri 13 Jul 01 21:59
To: 'ukha_d@xxxxxxx'
Subject: RE: [ukha_d]Now
Comfort
new install was Alarm Failure
Well I’ve returned from Andrew in Chester
with a Box
load of Goodies
Just assembled everything in the main panel ready
t
install tomorrow
Andrew knows his stuff and has a great little
set-up
in Comfort
There are a couple of demo systems up and running
And its easy t see what each bit does and its
purpose
I still think there is a massive overlap between
HomeVision and Comfort
I’ll tell you how I’ve sorted mine
when its finished
(that will be about 2003 !!)
My biggest worry at the moment is disconnecting
my
present alarm and tracing all the old
circuits
Especially the outside
siren
Andrews given me a few hints lets hope I
don’t annoy
the neighbours too much
Mike
Sent from Home
____________________________________
Automated Home UK
http://www.automatedhome.co.uk
____________________________________
Your use of
Yahoo! Groups is subject t the Yahoo!
Terms of Service.